Allis Chalmers Substation Transformer (1). Remanufactured by Jordan Transformer LLC, August 2009, Job No. 4569. 69,000 Volts. Vendor has PCB test analysis, < 1 ppm. 6.49% KVA @ 12,000 KVA
– Limited usage last 4 years
– Serial # 26311018921
– All windings are copper & circular design
– 3 Phase 60 hertz substation transformer
– 12/16/20 MVA OA/FA/FA @ 55 Deg. C
– Original Manufacturer Allis Chalmers 4/1961
AFC Dunk/Spray Washer
AFC Dunk/Spray Washer. Gas fired with working dimensions of 36” X 48” X 30” high. Serial number 60702. 480 violt, 3 phase, built in 1993. Currently set up to be loaded with a vacuum loader but could easily be converted back to a charge car configuration. Good condition.
Asking $10,000 USD.
Houghton Aqua Quench 3699 Polymer (4)
Houghton Aqua Quench 3699 Polymer (4). Available for sale are four (4) Totes of Houghton Aqua Quench 3699 Polymer Quenchant. Material has never been used. Total amount available is 1,000 Gallons.
Asking Price is $2,500.00.
Closed Loop Water Cooling System
Closed Loop Water Cooling System. Manufactured by Dry Coolers in 2010. Model #CDX-150-120-ST. 480V/227V/30/60Hz. Closed loop system with air cooled heat exchanger, model AVR-35-15. S/NJ-4720. 15GPM. Controls: Mounted and wired in an enclosure attached to the pumping system includes digital temperature control, disconnect switch etc. Excellent condition.
Asking $7,950.00 USD.
Tenaxol Quench Oil Accelerator
Tenaxol Quench Oil Accelerator. Available are 6 new, unopened 55 gallon drums of Tenaxol Quench Oil Accelerator for use with Park AAA quench oil. New this was $900.00 USD/drum,
Asking $450.00 USD/drum.
Nitrogen Generating System
Nitrogen Generating System. Manufactured by South Tek Systems in 2013 this system is in “like new” condition. The unit includes; STS N2-GEN 200S with Oxygen Analyzer, 1,060 Nitrogen Storage Tank, Kaeser ASD40T Complete Air Compressor package with Refrigerant Dryer and 240 Gallon Air Receiver Tank, Connection Package. Performance Capabilities: Nitrogen Purity Ranging from 95% – 99.999%, Nitrogen Hourly Flow Rate Ranging from: 473 SCFH – 5,371 SCFH *depending on purity setting, Nitrogen Outlet Pressure Range: 0 – 80 PSI. Excellent condition, available the end of June.
Asking $82,500.00 USD.
Eclipse Burners, Recuperators and Spark Igniters
Eclipse Burners, Recuperators and Spark Igniters. All of these items are in “like new” condition and still in the original boxes. Vendor will sell as a complete package or as individual items. Recuperators; Eclipse Bayonet Ultra Recuperator, Assembly 101849-24 (5BU, 24” tube length, low pressure drop model). S/N 07-27834580-8 45 units in inventory.
Asking $1840 USD each.
TFB Burners; Eclipse Therm thief V2.3, Model TFB23.030NP04NA9NXXR. Model: 030 – Burner Model 030, Fuel Type: N – Natural Gas (CH4), Air Supply: P – Preheated Air, Burner Input: 04 – 201k-300k Btu/h (59-88 kW), Gas Piping Connection: N – NPT Gas Inlet Connections. Gas Orifice: A9 – 9.1mm. Air Pipe Connection: N – NPT Air Inlet. Air Orifice: XX – No orifice (for preheated air). Tube Length: R – 20 in. (507 mm). Cone Setting: C – 9.5mm. Flame Supervision: X – No Flame Safety. Gas Piping Orientation: 0 – Gas Inlet at 0 Degrees with Air Inlet at 0 Degrees. S/N 10S0101049-0001-6. Manufactured June/2012. 40 units in inventory.
$695 USD each.
Spark Plug Igniters. Model # 100640-11. 40 units in cardboard tubes with bubble wrap.
$100 USD each.
Surplus Cast Link Belt
Surplus Cast Link Belt. Used Omega HT Cast Link belt with HR 120 connecting rods. 4” pitch, 78” wide X 130’ long. Weight 26,741 pounds. Also available is a porcupine drive roll, 11’ long, 700 pounds. A tail roll 11’ long X 11” diameter, 700 pounds, entry and exit hearth rolls 10.5’ long X 6” diameter and a return roll 10.5’ long X 14.4” diameter. Good condition. Buyer can inspect condition upon request.
Please call for pricing – Gord: 905.271.0033
Hi Tech Weighing System
Hi Tech Weighing System. Excellent condition Hi Tech vibratory loading system suitable for a continuous furnace. Model PC 325-2 TEEDC, 460 VAC 60Hz, S/N 0546, built 03/09/02.
Asking $6,000 USD.
AGF Rotary Washer
AGF Rotary Washer. Model RCW-W-R 23-2.5-4-4 gas fired rotary washer manufactured by American Gas Furnace Company. 23” diameter retort with 48” of washing and 48” of rinsing. Operating temperature of 150F-180F. Overall size is 13’ long X 7.5’ wide X 7’ 10”. Very good condition.
Asking $6,000 USD.
Cryogenic Stainless Twin Tank
Cryogenic Stainless Twin Tank. Manufactured by NDA Engineering in 2006. Operating temperature to -346F. 240 Volt. from Internal dimensions left hand side 70cm x 65cm x 80 cm deep (364 litres), right hand side 70cm x 100cm x 80cm deep (560 litres)
Asking Price $6,500 USD. Located in New Zealand.
Giant Finishing Machine
Giant Finishing Machine. Manufactured by “Giant”, Model GB-10 Spiral bowl with Internal Seperation Vibratory Deburring and Finishing Machine. 10 cubic foot process capacity with 5 hp motor. Maximum load capacity 2,000 pounds. Bowl diameter 65”, unload height 39”. NEMA 12 control panel including 0-6 hour process timer and lapsed time recorder. Control panel is JIC approved and U.L. listed. Standard voltage; 460/3/60 cycle. This is a brand new, unused tumbler. New this was $45,000 USD,
Asking $30,000 USD.
Water Cooling System
Water Cooling System. VFC 500 gallon, 10HP 150 GPM pump, 3500 rpm motor. Plate heat exchanger, Graham model VFX-18, s/n 93-10058-1. This unit was used on 5,000 lb. loads.
Asking $7,500.00 USD.
Wheelabrator – Bronco
Wheelabrator – Bronco. Model# SLC500. 36” Mesh Belt –VFD drive. 8 – 20hp Blasting Wheels – VFD drive. Media separator, Torrit dust collector. Some spare parts are also included. Well maintained and works well. Footprint – 30’ long, 16’ high, aprox. 12’ wide.
Asking Price: $39,900 USD. (Includes loading at the facility)
Georg Fischer Shot Blast System
Georg Fischer Shot Blast System. This unit is currently installed and in very good condition. Included are $10,000 worth of spare parts.
Asking $20,000 USD.
1 Surface Combustion Radiant Tube and 4 supports
1 Surface Combustion Radiant Tube and 4 supports. Brand New the cost was $1,844 for the tube and $448 each for the supports for a total of $3,636 in 2014. The radiant tube is Surface Combustion inventory # 850628 and the support is part # 70R64/L. They are a set for a Standard Allcase furnace. One leg of the tube is 3/12 inches in diameter and 62 inches long. The other is 4 ½ inches in diameter and 60 inches long.
Asking $3,000 USD.
SBS Quench Airs (2 available)
SBS Quench Airs (2 available). Manufactured by SBS Corp., these are air/oil quench oil coolers. Each is a 3 fan unit with disconnect and 480 volt. Suitable for a large continuous line. Installed indoors. Very good condition.
Asking $12,500 USD each. Must be removed within the next few months All Offers Considered.
Wheelabrator Rubber Belt Tumblast
Wheelabrator Rubber Belt Tumblast. Model # TBR-12, Serial # A142403, Voltage 480/3/60, 12 cubic feet, Controls – complete. Available Immediately, very good condition.
Asking: $55, 000.00 USD.
Dual Lane Conveyor Washer
Dual Lane Conveyor Washer. Heated: Natural Gas. Dual Lane Washer Serial Number: 08-010 (2008). Max Temperature: N/A. Voltage: 480/3/60. Work Area: 11″W x 7″H. Each Lane External Dimensions: 8’W x 10’6H x 30’L – approx. Controls: Mounted and wired in an enclosure attached to the washer. Includes an Allen Bradley MicroLogix 1200 PLC and an Allen Bradley “Powerflex 4” VFD to control conveyor belt speed. Description: This washer has three (3) stages, wash/rinse/blow-off. This washer is gas fired using Eclipse burner and gas train with a Honeywell UDC digital temperature control. Spray nozzles are located on top, both sides and bottom. Condition: Very Good.
Asking: $39,500.00 USD.
SBS Unit. Specs: S/N: 4926. Year: 2007. Three (3) Fans with side mounted disconnects. Overall Size: 6’w x 6’h x 21’l. W-RES, MAWP 75 psi @ 450°F, MBMT -20°F, 75 psi.
Ipsen Automatic Dunk/Spray Washer
Ipsen Automatic Dunk/Spray Washer. Model #WRD-11, Serial Number 57690. Working dimensions of 36″ wide X 48″ deep X 24″+ high, 2200 pound capacity. Electrically heated, 72KW. Companion washer-In/Out or straight through design. Door each end, Cal Rod element bundle. 12″ wide belt oil skimmer, air operated-full width elevator rack for submerged oscillation, overhead spray rinse. Overall dimensions of 7′ 5″ wide X 5′ 4″ long X 11′ 8″ high. Rebuilt,
excellent condition asking $35,000 USD.
SBS “QuenchAir”. SBS Corporation air/oil quench oil cooler. Single fan unit model 5084-Q4. Serial number: 2365, 230/460 voltage, overall size: 74″wide X 104″long X 55″high. Comes with disconnects. Very good condition.
Asking $5,500.00 USD.
AFC Charge Car
AFC Charge Car. Drawing # MT-237014. Voltage 480/3/60. Suited for a 36” wide X 48” tray. External dimensions of 100” wide X 84” deep X 84” high. Side mounted control panel with Allen Bradley SLC 500 PLC Logic Control. Double ended chain driven powered charge car with roller rail top. Excellent condition.
Asking $28,500.00 USD.
Berg Water Chiller
Berg Water Chiller. This is a BERG Air Cooled portable Chiller, Model PA-1.5-1P capable of supplying 1.5 tons of cooling capacity at 15 degrees F leaving and 95 degrees F ambient temperature. Used for only 3 days (low hours), and is in nearly new condition. Electrics are 460/3/60 and it comes with a 575-460 transformer.
Holcroft Dunk/Spray Washer
Holcroft Dunk/Spray Washer. Model GPWS 24-36-24. Electrically heated, 480/3/60/50 amps. Working dimensions of 24″ wide X 24″ high X 36″ deep. External dimensions of 96″W X 143″ high X 124″ long (91″ without skimmer attached). This is a standard dunk/spray washer with 4 Warren Electric immersion heaters. Spray nozzles are arranged over and all sides of the wash area. Load height is 51″ from floor to top of rollers. Wheel centres are 14-1/2″. Controls are mounted and wired on the right hand side of the washer and includes all necessary pushbuttons and signal lights. There is a dunk cycle timer and spray cycle timer. A Honeywell UDC 2000 digital temperature controller controls wash temperature. Good condition.